Middleby Marshall PS314SBI Installation Manual download pdf (Page 10)

ENGLISH

SECTION 2 - INSTALLATION

Figure 2-13 - Final Assembly - Front

VI. FINAL ASSEMBLY

1. For gas ovens, attach the flue vent to the rear wall of the oven

as shown in Figure 2-13. Use one #10-16 x 3/8" screw and

two #10-32 x 3/4" screws. All three screws are provided in

the Installation Kit.

2. Install the motor housing, and secure it in place with its five

mounting screws. Two screws are located on the back wall

of the oven, while three are located on the hanger bracket

on the left end panel. See Figure 2-13.

3. Install the conveyor extension covers over the ends of the

conveyor frame. See Figure 2-13.

4. Check that the cool panels are properly mounted, as shown

in Figures 2-13 and 2-14. Slots on the back of the panels

fit over the hangers on the walls of the oven. One cool panel

is attached to the front of the oven, while two are attached

to the rear.

5. Attach the exit tray(s) at the drive (left) end of the conveyor.

See Figure 2-15.

6. Install the crumb trays underneath the conveyor as shown

in Figure 2-15. First, place the inside edge of the tray onto

the bracket attached to the end plug. Then, swing the

outside edge of the tray up and into place.

Figure 2-14 - Final Assembly - Rear

Motor

shroud

3 upper

screws

Extension cover

(idler end)

Front cool

panel

Hangers on oven

wall fit into slots on

cool panels

Extension cover

(drive end)

2 rear

screws

Flue vent

(gas ovens

only)

Figure 2-15 - Final Assembly - Exit Tray(s) and Crumb Trays

2 rear

#10-16 x 3/4"

screws

Rear cool

panels

Drive-end rear

panel notched for

motor shroud

1 bottom

#10-32 x 3/8"

screw

Crumb tray

Exit tray(s)

Conveyor extension Conveyor frame

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Middleby Marshall PS314SBI Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Ovens Middleby Marshall PS314SBI