Middleby Marshall Model PS536 Installation Manual download pdf (Page 10)

ENGLISH

C. Restraint Cable Installation

Because the oven is equipped with casters, a restraint cable

assembly must be installed to limit the movement of the

appliance without depending on the connector and the quick

disconnect device or its associated piping. One end of the cable

is anchored to the eyebolt on one of the rear leg extensions,

while the other is anchored to the wall. See Figure 2-7.

After connecting the restraint cable, move the oven to its final

location. Then, lock the two front casters.

3/8"-16 x 1"

eyebolt on

rear leg

extension

Restraint cable

assembly

3/4 (19mm)

eyebolt

Wall of

structure

Figure 2-7 - Installing the Restraint Cable

B. Stacking

For single ovens, skip ahead to Part C, Restraint Cable

Installation. For double or triple ovens, continue on to Step

1, below.

1. Assemble the stacking spacer(s) as shown in Figure 2-5.

One spacer assembly is supplied for a double oven, while

two are supplied for a triple oven.

2. Place one of the assembled spacers on top of the lower

oven cavity, making sure that the insulation faces up.

3. Place the center oven cavity (for triple ovens) or the top oven

cavity (for double ovens) on top of the spacer. Check that

all four sides of the spacer overlap the base of the oven, and

that the oven is level and firmly seated. See Figure 2-6.

4. For triple ovens, repeat Steps 2 and 3 to install the top oven

cavity.

Figure 2-5 - Assembling the stacking spacers

#10-32 x 1/2"

hex screws

1-1/2" (38mm)-thick

insulation, pre-cut

Stacking panel,

P/N 44837

Top panel,

P/N 42882

Figure 2-6 - Stacking

Assembled

spacer

(insulation

faces up)

SECTION 2 - INSTALLATION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Middleby Marshall Model PS536 Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Ovens Middleby Marshall Model PS536