Middleby Marshall Model PS536 Installation Manual download pdf (Page 9)

ENGLISH

SECTION 2 - INSTALLATION

III. ASSEMBLY

A. Top Panel and Base Pad Assembly

1. Install the four leg extensions onto the base pad using the

3/8"-16x1" screws, 3/8" flat washers, and 3/8" lockwashers

supplied in the Base Pad Kit. See Figure 2-3. Check that

the finished sides of each leg extension face OUTWARDS.

One rear leg should be attached using three 3/8"-16 x 1"

screws and the 3/4" eyebolt, as shown in Figure 2-3. This

eyebolt acts as the anchor point for the restraint cable

assembly (see Part C,

Restraint Cable Installation).

2. Install one caster onto each leg extension, as shown in

Figure 2-4. Use the 3/8"-16x1" screws, 3/8" flat washers,

and 3/8" lockwashers supplied in the Installation Kit. The

locking casters should be installed at the FRONT of the

oven. The non-locking casters should be installed at the

REAR of the oven.

3. Install the top panel in place on the top oven cavity using the

screws included in the base pad kit, as shown in Figure 2-

4. Install the lower oven cavity onto the base pad. Check that

the eyebolt welded onto the pad faces the rear of the oven.

Figure 2-3 - Leg extension and casters installation

Locking casters -

FRONT of oven

Non-locking casters -

REAR of oven

3/8" flat

washer

3/8" lock

washer

3/8"-16 x 1"

hex screw

3/8" flat

washer

3/8" lock

washer

3/8"-16 x 1"

hex screw

Finished sides of

leg extension

face corner of

base pad

3/4" eyebolt

(inside corner of

one rear leg

extension

only)

Figure 2-4 - Top panel and base pad installation

#10 x 1" screws

attach front of

top panel

#10 x 2" screws

attach rear of

top panel

Top oven

cavity

Bottom oven

cavity

Assembled

base pad

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Middleby Marshall Model PS536 Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Ovens Middleby Marshall Model PS536